Modified Sine Wave Inverters 1000W

When you choose battery priority(Battery type selector on 7-9),then inverter will invert from battery despite the AC input. Only when the battery voltage reaches low voltage alarm point will be inverter transfer to AC input,charge battery when the battery is fully charged. This function is mainly for wind/’ solar systems using utility power as back up.

Consultar Ahora Siguiente Producto

Característica de producto

Features

It is an electronic system that operates the photovoltaic(PV)modules in a manner that allows the modules to produce all the power they are capable of. The solar panel charge controller is a microprocessor-based system designed to implement the MPPT. It can increase charge current up to 30% or more compared to traditional charge controllers.

AC or Battery Priority

Our inverter is designed AC priority by default.This means,when AC input is present, the battery will be charged first.

Maximum Power Point Tracking(MPPT)function

Maximum Power Point Tracking,frequently referred to as MPPT,is an electronic system that operates the Photovoltaic(PV)modules in a manner that allows the modules to produce all the power they are capable of. The solar panle charge controller is a microprocessor-based system designed to implement the MPPT And it can increase charge current up to 30% or more compared to traditional charge controllers.

Characteristics

12/24vdc input optional

Max. AC charge current 70A.(Optional) Inbuilt pure copper transformer

Pure sine wave output

CPU single chip intellectual control technology Battery priority function

50Hz/60Hz Automatic

Mostrar detalles

Model		RTI 1024	RTI 1524	RTI 2024	RTI 3024	RTI 5048	RTI 6048	RTI 10048
MPPT Solar Function	Rated Voltage	24				48
	Rated Charge Current	40A				60A
	Load Current	15A
	Input Voltage Range	15-150V DC
	Max.PV open circuit array voltage	150V DC
	Typicle Idle Consumption	At idle<10mA
	Over load protection(Dc load)	2.0Inom>5s; 1.5Inom>20s; 1.25*Inom temperature controlled
	Bulk charge	14.6V(default)		29.2V(default)		29.2V(default)
	Floating charge	13.4V(default)		26.8V(default)		53.6V(default)
	Equalization charge	14.0V(default)		28.0V(default)		56.0V(default)
	Over charge disconnection	14.8V		29.6V		59.2V
	Over charge recovery	13.6V		27.2V		54.4V
	Over charge disconnection	10.8V(default)		21.6V(default)		43.2V(default)
	Over charge reconnection	12.3V		24.6V		49.2V
	Temperature compensation	-13.2mV/C		-26.4mV/C		-52.8mV/C
	Load acid battery setting	Adjustable
	NiCad battery setting	Adjustable
	Load Control Mode	1.Low Voltage Reconnect(LVR):Adjustable; 2.Low Voltage Disconnect(LVD):Automatic
		disconnection;3.Reconnection:Includes warning flash before disconnect and reconnection
	Low voltage reconnect	12.0-14.0Vdc		26.0-28.0Vdc		48.0-56.0Vdc
	Low voltage disconnect	10.5-11.0Vdc		21.0-22.0Vdc		42.0-50.0Vdc
	Ambient temperature	0 to 40°C(full load) 40-60°C(de-rating)
	Altitude	Operating5000m, Non-Operating 16000m
	Protection class	IP21
	Battery temperature sensor	BTS optional remote battery temperature sensor for increased charging precision
	Terminal size(fine/single wire)	#8 AWG
PV Inverter Battery Priority	Input voltage wave form	Sinusoldar(Utility or Generator)
	Nominal input voltage	230Vac
	Low line disconnect	155Vdc±4%
	High line disconnect	285Dvc±4%
	Max Ac input voltage	270Vrms
	Nominal Input Frequency	50Hz/60Hz(Auto Detection)
	Over load protection	Circuit Breaker
	Output short Circuit Protection	Circuit Breaker
	Efficiency Line Mode	>95%
	Transfer switch rating	30A
	Transfer time(Ac to Dc)	20ma(Typical)
	Output voltage Waveform	Pure Sine Wave
	Rated Output Power(W)	1000W	1500W	2000W	3000W	5000W	6000W	10000W
	Power Factor	1
	Nominal Output Voltage	230Vac
	Output Voltage Regulation	±10%rms
	Nominal Efficiency	>80%
	By Pass	Optional
	AC Charger	Optional
	Charge Current Regulation	±5A
	Battery Initial Voltage	0-15.7Vdc/31.4Vdc(can operate with 0V battery)
	Communication	Rj11(Used for Factory Testing, No Customer Interface Available)
	Safety Certification	CE(EN80950)
	EMI Classification	EN50091-2 class A
	Operating Temperature range	0°C to 40°C
	Storage Temperature	-15°C-60°C
	Operation Humidity	5% to 96%
	Audible Noise	60dB Max.
	Cooling	Forced Air Variable Speed Fan

Output Input Protection	OUTPUT VOLT	100/110/120/220/230/240VAC
	CONTINUOUS POWER	300W	500W		600W			800W
	SURGE POWER	600W	1000W		1200W			1600W
	WAVEFORM	PURE SINE WAVE
	FREQUENCY	50Hz/60Hz
	AC REGULATION	LOW & HIGH 10%
	NO LOAD CURENT DRAW	<0.6A
	EFFICIENCY	>88%
	USB OUTPUT	5V
	DC VOLTAGE	LED DISPLAY POWER & FAIL STATUS
	INPUT RANGE	10-15VDC		21-30VDC			40-60VDC
	WORKING INPUT	12VDC		24VDC			48VDC
	FUSE	35A		20A			15A
	LOW BATTERY ALARM	10.5+0.3V		21+0.5V			42±0.5V
	LOW BATTERY SHUT DOWN	10+0.5V		20+0.5V			40±0.5V
	OVER VOLTAGE SHUT DOWN	15.5+0.5V		30.5+0.5V			60±0.5V
	OVER LOAD SHUT DOWN	360W OVER10 SECOND	600W OVER10 SECOND			720W OVER10 SECOND			960W OVER10 SECOND
	OVER HEATING SHUT DOWN	>75°C
	OVER THERMAL	SHUT DOWN THE OUTPUT
	WORKING TEMPERATURE	BETWEEN -10°C AND +50°C

Todos los productos